Question on radius

["Delfos, Jacob" <jacob.delfos (at) maunsell.com>]

Nick,

I'm assuming you are referring to the radius for querying? In your layer
you should have a definition something like:
    TOLERANCE 3
    TOLERANCEUNITS PIXELS

It kind of speaks for itself. If you add these parameters and set them
properly, it should work better.

Regards,

Jacob

> -----Original Message-----
> From: chameleon-bounces (at) lists.maptools.org 
> [mailto:chameleon-bounces (at) lists.maptools.org] On Behalf Of 
> Nick Gorbikoff
> Sent: 21 February 2006 01:23
> To: chameleon (at) lists.maptools.org
> Subject: [Chameleon] Question on radius
> 
> Hello Everyone.
> I have a question on Radius settings. I looked everywhere but 
> couldn't 
> find a definite guide on it. Basically my  question is where do I 
> control radius for the Point of Interest. It seems that no 
> matter what I 
> do I still get the same result for  as it gives me results 
> within 1 mile 
> - not less not more.
> 
> Thank you
> 
> Nick
> 

_______________________________________________
Chameleon mailing list
Chameleon (at) lists.maptools.org
http://lists.maptools.org/mailman/listinfo/chameleon