Re: 2 PCCS6 in one system?

From: Jan Mlynar

When your board is an ISA form factor, then yes. You have to download
firmware mtp76.dc2. When your board is PCI or cP, then still use ss7.dc2
but
specifying MTP2 as a <run_mode> parameter while resetting the board. You
can
have another kind of troubles, because I'm not sure, if you can run MTP2
on
the board with ISUP (or other higher) licence button - in that case you w
ill
get the message, that your licence is not correct.

Jan Mlynar

----- Original Message -----
From: "General Listmanager" <General.listmanager@pysdiscussext.py.intel.c
om>
To: <Recipients of 'General' suppressed>
Sent: Tuesday, March 23, 2004 7:16 AM
Subject: Re: 2 PCCS6 in one system?

> From: DSP K.
>
>
> Hi Jan,
>
> Thank you very much for your kind reply.
> I am trying to move MTP3 to host but GCTLOAD
> request another license file for FORK_PROCESS mtp_nt.exe. I have no ide
al
about this file. Is MTP76.dc2?
>
> Hans
> ¡@
>
> On 3/22/2004 3:31:01 AM, Jan Mlynar wrote:
> >If you have two Septel boards
> >in one chasis, you have to use
> >host based MTP3
> >and upper layers. So, only
> >MPT2 should be running on the
> >board.
> >
> >In the case, you don't need
> >route messages between boards
> >(on MTP3), there
> >is possibility to run gctload
> >twice - one for each board,
> >but the easier way
> >in this case is to have single
> >board in a chasis.
> >
> >Jan Mlynar
> >
>
>
>
>
>
>
> To reply: mailto:General.27778@pysdiscussext.py.intel.com
> To start a new topic: mailto:General@pysdiscussext.py.intel.com
> To login: http://members.support.dialogic.com/wbproxy/wbpx.dll/~general
>
>
>
>

To reply: mailto:General.27779@pysdiscussext.py.intel.com
To start a new topic: mailto:General@pysdiscussext.py.intel.com
To login: http://members.support.dialogic.com/wbproxy/wbpx.dll/~general
Received on Tue Mar 23 02:34:37 2004